To Install A Window/Door Sensor - Carrier WIRELESS STANDARD SENSOR Installation Manual

Installing the Wireless Adapter and sensors
4
Put the sensor on the mounting plate so that the tabs on the plate are inserted into the cutouts on the back
of the sensor. Twist the sensor clockwise until it clicks into place.
To preserve battery life
Maintain at least 700 lux in the space where the sensor is installed, and set the sensor's Heartbeat interval to the
default number or higher. Low lux and frequent signals can significantly impact battery life.

To install a Window/Door sensor

Install the sensor and magnet on the interior side of the door/window.
•
Door installation—Install the magnet on the knob side of the door (opposite side from the hinges). Install the
sensor on the door frame. Install these at least 1 ft. (3O cm) above the floor to avoid damage.
•
Window installation—Install the magnet on the window and the sensor on the window frame where it will not
be exposed to water.
Wireless Sensors
Installation Guide
36
CARRIER CORPORATION ©2018
All rights reserved