Using Sensorscan To Determine The Best Location For Devices; Step 1: Download And Install Sensorscan - Carrier WIRELESS STANDARD SENSOR Installation Manual

Using SensorScan to determine the best location for devices

Using SensorScan to determine the best location for devices
Use the SensorScan software to verify that your proposed locations for sensors and the Wireless Adapter will allow
a strong wireless signal. If needed, review Wireless device placement guidelines (page 18) for locations or
obstacles to avoid.
PREREQUISITES
•
A computer with Microsoft® Windows operating system
•
USB Radio

Step 1: Download and install SensorScan

1
On the computer, go to http://www.hvacpartners.com (http://www.hvacpartners.com), select Support Center
> Controls Support > Software Downloads > i-Vu Technicians Tools, and then download
SensorScan_Setup.exe.
2
Insert the USB Radio into a USB port on your computer.
3
Run SensorScan_Setup.exe and follow the prompts to install the software.
4
Start the SensorScan application.
• If the USB Radio driver installed correctly, the application should show something similar to the image
below.
• If the driver did not automatically install correctly, see To install the USB Radio driver (page 25).
NOTE The USB Radio can talk to only one application at a time. If you need to run SensorBuilder and SensorScan
simultaneously, you can do either of the following:
•
Use two USB Radios.
•
Turn off communication with the USB radio in the current application, then switch to the other application and
turn on the USB communication.
Wireless Sensors
Installation Guide
26
CARRIER CORPORATION ©2018
All rights reserved