To Install A Pro-F Sensor - Carrier WIRELESS STANDARD SENSOR Installation Manual

Installing the Wireless Adapter and sensors

To install a Pro-F sensor

The sensor can be mounted directly on a wall or mounted to a backplate.
1
Push the tab shown below as you slide the mounting plate down until the plate's tabs align with the sensor's
notches.
Push tab in
and slide
mounting
plate down...
2
Remove the mounting plate from the sensor.
3
Attach the mounting plate to the wall using the provided mounting screws.
4
Place the sensor on the mounting plate, aligning tabs and notches, and then slide the sensor downward until
you hear the tab click.
Pro-F batteries
The Pro-F sensor uses two non-standard SAFT LS-14500 AA 3.6V batteries that have a life expectancy of 5 to 10
years. If the icon appears on the Pro-F's screen, the sensor has a low battery. The battery is not user-
replaceable, and sensor should be replaced. If the sensor is still under warranty, the warranty will be voided if the
sensor is opened.
However, if you choose to replace the battery, use a Torx 6.5 screwdriver to remove the 4 screws from the back of
the sensor. Be sure to orient the batteries correctly as incorrect orientation will make the sensor permanently
inoperable.
Wireless Sensors
Installation Guide
Mounting
plate
...until tabs
align with
34
notches
CARRIER CORPORATION ©2018
All rights reserved