Wiring The Main Power Supply Cable To The I/O Junction Box - Filtec FT-70c Service And Technical Reference Manual

Warning
Industrial Dynamics Company, Ltd. © Form 40256-0600
4. Wire the main power cable to the FT-70 power filter wiring.
Connect the Power Cable:
Hot
Neutral
Ground

Wiring the Main Power Supply Cable to the I/O Junction Box

Refer to wiring diagram in Chapter 11 when performing this
procedure.
Disconnect all electrical power sources from the equipment before
attempting any installation procedure. Failure to do so can result
in personal injury and equipment damage.
1. Remove one of the plugs in the bottom of the junction box and
install a liquid tight fitting.
2. Route the main power cable from the main power supply
through the cable opening and into the Junction Box.
No. Description
1 Cable Opening/Plug
Figure 3-23. Route the Power Cable into the Junction Box.
Chapter 3: Installing the FT-70
To the FT-70:
Brown
Blue
Ground Stud
1
3-25