Table of Contents
Advertisement
exclude
Syntax
[no] exclude group-name [group-name...(up to 5 max)]
Context
config>router>mpls>lsp>primary
config>router>mpls>lsp>secondary
Description
This command specifies the admin groups to be excluded when an LSP is set up. . Up to 5 groups per
operation can be specified, up to 32 maximum. The admin groups are defined in the
config>router>mpls>admin-group context.
Use the no form of the command to remove the exclude command.
Default
no exclude
Parameters
group-name — Specifies the existing group-name to be excluded when an LSP is set up.
hop-limit
Syntax
hop-limit number
no hop-limit
Context
config>router>mpls>lsp>primary
config>router>mpls>lsp>secondary
Description
This optional command overrides the config router mpls lsp lsp-name hop-limit command. This
command specifies the total number of hops that an LSP traverses, including the ingress and egress
routers.
This value can be changed dynamically for an LSP that is already set up with the following
implications:
If the new value is less than the current hops of the established LSP, the LSP is brought down. MPLS
then tries to re-establish the LSP within the new hop-limit number. If the new value is equal or more
than the current hops of the established LSP then the LSP will be unaffected.
The no form of this command reverts the values defined under the LSP definition using the config
router mpls lsp lsp-name hop-limit command.
Default
no hop-limit
Parameters
number — The number of hops the LSP can traverse, expressed as an integer.
7950 SR OS MPLS Configuration Guide
Values
2 — 255
MPLS and RSVP
Page 293
Advertisement
Chapters
Table of Contents
