Table of Contents
Advertisement
MPLS Commands
Parameters
percent — Specifies the minimum difference between the current bandwidth reservation of the LSP
mbps — Specifies the minimum difference between the current bandwidth reservation of the LSP and
adjust-up
Syntax
adjust-up percent [bw mbps]
no adjust-up
Context
config>router>mpls>lsp>auto-bandwidth
Description
This command configures the minimum threshold for increasing the bandwidth of an LSP based on
active measurement of LSP bandwidth.
The no form of this command is equivalent to adjust-up 5.
Default
no adjust-up
Parameters
percent — Specifies the minimum difference between the current bandwidth reservation of the LSP
mbps — Specifies the minimum difference between the current bandwidth reservation of the LSP and
max-bandwidth
Syntax
max-bandwidth mbps
no max-bandwidth
Context
config>router>mpls>lsp>auto-bandwidth
Description
This command configures the maximum bandwidth that auto-bandwidth allocation is allowed to
request for an LSP or SDP.
Page 270
and the (measured) maximum average data rate, expressed as a percentage of the current
bandwidth, for decreasing the bandwidth of the LSP.
Values
1 — 100
Default
5
the (measured) maximum average data rate, expressed as an absolute bandwidth (mbps), for
decreasing the bandwidth of the LSP.
Values
0 — 100000
Default
0
and the (measured) maximum average data rate, expressed as a percentage of the current
bandwidth, for increasing the bandwidth of the LSP.
1-100
Default
5
the (measured) maximum average data rate, expressed as an absolute bandwidth (mbps), for
increasing the bandwidth of the LSP
Values
0 — 100000
Default
0
7950 SR OS MPLS Configuration Guide
Advertisement
Chapters
Table of Contents
