Table of Contents
Advertisement
Tools Commands
(6) * Label : 131071
-----------------------------------------------------------------------
Total RSB Count
trap-suppress
Syntax
trap-suppress number-of-traps time-interval
Context
tools>perform>router>mpls
Description
This command modifies thresholds for trap suppression. The time-interval parameter is used to sup-
press traps after a certain number of traps have been raised within a period. By executing this com-
mand, there will be no more than number-of-traps within time-interval.
Parameters
number-of-traps — Specifies to suppress the number of traps raised within a period.
time-interval — Specifies to suppress a certain number of traps raised within a period.
tunnel-interface
Syntax
[no] tunnel-interface rsvp-p2mp lsp-name [sender sender-address]
Context
config>router
config>router>igmp
Description
This command creates a tunnel interface associated with an RSVP P2MP LSP. IPv4 multicast packets
are forwarded over the P2MP LSP at the ingress LER based on a static join configuration of the
multicast group against the tunnel interface associated with the originating P2MP LSP. At the egress
LER, packets of a multicast group are received from the P2MP LSP via a static assignment of the
specific <S,G> to the tunnel interface associated with a terminating LSP.
At ingress LER, the tunnel interface identifier consists of a string of characters representing the LSP
name for the RSVP P2MP LSP. The user can create one or more tunnel interfaces and associate each
to a different RSVP P2MP LSP.
At egress LER, the tunnel interface identifier consists of a couple of string of characters representing
the LSP name for the RSVP P2MP LSP followed by the system address of the ingress LER. The LSP
name must correspond to a P2MP LSP name configured by the user at the ingress LER. The LSP
name string must not contain "::" (two :s) nor contain a ":" (single ":") at the end of the LSP name.
However, a ":" (single ":") can appear anywhere in the string except at the end of the name.
Default
none
Parameters
rsvp-p2mp lsp-name — Specifies the LSP. The LSP name can be up to 32 characters long and must
sender sender-address — Specifies system address of the ingress LER for the P2MP RSVP LSP.
Page 236
: 2
Values
100 — 1000, in multiples of 100
Values
1 — 300
be unique.
7950 SR OS MPLS Configuration Guide
Advertisement
Chapters
Table of Contents
