Table of Contents
Advertisement
Peer Parameters Commands
Peer Parameters Commands
peer-parameters
Syntax
peer-parameters
Context
config>router>ldp
Description
This command enables the context to configure peer specific parameters.
peer
Syntax
[no] peer ip-address
Context
config>router>ldp>peer-parameters
Description
This command configures parameters for an LDP peer.
Default
none
Parameters
ip-addr — The IP address of the LDP peer in dotted decimal notation.
auth-keychain
Syntax
auth-keychain name
Context
config>router>ldp>peer-parameters>peer
Description
This command configures TCP authentication keychain to use for the session.
Parameters
name — Specifies the name of the keychain to use for the specified TCP session or sessions. This
authentication-key
Syntax
authentication-key [authentication-key | hash-key] [hash | hash2]
no authentication-key
Context
config>router>ldp>peer-parameters>peer
Description
This command specifies the authentication key to be used between LDP peers before establishing
sessions. Authentication uses the MD-5 message-based digest. Peer address has to be the TCP ses-
sion transport address.
The no form of this command disables authentication.
Page 418
keychain allows the rollover of authentication keys during the lifetime of a session up to 32
characters in length. Peer address has to be the TCP session transport address.
7950 SR OS MPLS Configuration Guide
Advertisement
Chapters
Table of Contents
