Table of Contents
Advertisement
MPLS Commands
auto-bandwidth-multipliers
Syntax
auto-bandwidth-multipliers sample-multiplier number1 adjust-multiplier number2
no auto-bandwidth-multipliers
Context
config>router>mpls>
Description
This command specifies the number of collection intervals in the adjust interval.
Parameters
sample-multiplier number1 — Specifies the mulitplier for collection intervals in a sample interval.
adjust-multiplier number2 — Specifies the number of collection intervals in the adjust interval.
cspf-on-loose-hop
Syntax
[no] cspf-on-loose-hop
Context
config>router>mpls>
Description
This command enables option to do CSPF calculation till the next loose hop or the final destination of
LSP on LSR. On receiving a PATH message on LSR and processing of all local hops in the received
ERO, if the next hop is loose then the LSR node will first do a CSPF calculation till the next loose
hop. On successful completion of CSPF calculation, ERO in PATH message is modified to include
newly calculated intermediate hops and propagate it forward to the next hop. This allows setting up
inter-area LSPs based on ERO expansion method.
NOTE: LSP may fail to setup if this option is enabled on LSR that is not an area border router and
receives a PATH message without proper next loose hop in ERO.
'cspf-on-loose-hop' configuration is allowed to change dynamically and applied to new LSP setup
after change.
Default
no cspf-on-loose-hop
srlg-group
Syntax
[no] srlg-group group-name [group-name...(up to 5 max)]
Context
config>router>mpls>interface
Description
This command defines the association of RSVP interface to an SRLG group. An interface can belong
to up to 64 SRLG groups. However, each single operation of the srlg-group command allows a
maximum of 5 groups to be specified at a time.
The no form of this command deletes the association of the interface to the SRLG group.
Page 262
Values
1 — 511
Default
1
Values
1 — 16383
Default
288
7950 SR OS MPLS Configuration Guide
Advertisement
Chapters
Table of Contents
