Eyelet Bushing Removal - SRAM RockShox Deluxe RT3 Service Manual

E y e l e t B u s h i n g R e m o v a l
To replace damaged or worn out bushings, use the RockShox® rear shock bushing removal/installation tool.
Insert the threaded rod through the shaft eyelet until the base of the
1
push pin rests against the bushing.
Thread the large, open end of the catcher onto the rod until it rests on
the eyelet.
Clamp the catcher in a vise or hold it secure with a 13 mm wrench.
2
Use a second 13 mm wrench to thread the push pin along the rod until
the push pin pushes the eyelet bushing out of the eyelet.
13 mm 13 mm
Unthread the catcher from the threaded rod. Remove the tool from the
3
shaft eyelet and discard the old bushing.
Repeat steps 1-3 for the other eyelet.
Set the bushings aside until you have finished servicing
your shock.

Eyelet Bushing Removal

12