Table of Contents
Advertisement
E y e l e t B u s h i n g R e p l a c e m e n t
To replace damaged or worn out bushings, use the RockShox® rear shock bushing removal/installation tool.
Insert the threaded rod through the shaft eyelet until the base of the
1
push pin rests against the bushing.
Thread the large, open end of the catcher onto the rod until it rests on
the eyelet.
Hold the catcher secure with a 13 mm open end or adjustable wrench.
2
Use a second 13 mm wrench to thread the push pin along the rod until
the push pin pushes the eyelet bushing out of the eyelet.
13 mm
13 mm
Unthread the catcher from the threaded rod. Remove the tool from the
3
shaft eyelet and discard the bushing.
Repeat steps 1-3 for the damper body eyelet.
Set the RockShox rear shock bushing removal/installation tool aside
until you have finished servicing your shock.
Eyelet Bushing Replacement
10
Advertisement
Table of Contents
