Remote Cable And Housing Installation - Rlr Only; Parts, Tools, And Supplies; Remote Cable And Housing Installation - SRAM RockShox Deluxe RT3 Service Manual

R e m o t e C a b l e a n d H o u s i n g I n s t a l l a t i o n - R L R O n l y
To install new cable and housing into the OneLoc™ remote, consult the OneLoc Remote User Manual on www.sram.com/service.
P a r t s , T o o l s , a n d S u p p l i e s
Parts
• AM SVC kit 200h/1yr DLX RMT A1
• RMT Spring kit DLX/SDLX/SDLXC
• Shift cable and housing
Safety and Protection Supplies
• Safety glasses
• Nitrile gloves
R e m o t e C a b l e a n d H o u s i n g I n s t a l l a t i o n
RLR: After the housing has been routed and installed on the bicycle,
1
use a 5 mm open end wrench to thread a new ferrule onto the housing.
Do not push the housing into the ferrule.
RLR: Install the ferrule and housing into the reservoir, then use a 2 mm
2
hex bit socket to tighten the ferrule lock screw to 0.9 N·m (8 in-lb).
RLR: Thread the cable through the housing, spool, and under the cable
3
set screw. Pull the cable tight and use a torque wrench with a 2 mm
hex bit socket to tighten the cable set screw to 0.9 N·m (8 in-lb).
Common Tools
• 2 mm hex wrench
• 2 mm hex bit socket
• T25 TORX® wrench
• 5 mm open end wrench
• Torque wrench
• Cable and housing cutters
5 mm
2 mm

Remote Cable and Housing Installation - RLR Only

·m (8 in-lb)
2 mm
0.9 N
0.9 N·m (8 in-lb)
48