SRAM RockShox Deluxe RT3 Service Manual page 42

RLR: Install the spring preloader so that the spring tang slides into the
5
3 mm 2 mm
spring tang hole in the preloader.
Use a 3 mm hex wrench to preload the spring counter-clockwise until
the notch in the spring preloader lines up with the set screw hole, then
tighten the set screw to 0.8 N·m (7 in-lb)
Use a T25 TORX® wrench to test the spring tension.
NOTI CE
The spring preloader must be rotated counter-clockwise to preload the
spring.
3 mm
3mm 0.8 N·m (7 in-lb) 2 mm
Remote Spring Service - RLR only 42