SRAM RockShox Deluxe RT3 Service Manual page 47

Press an end spacer, large diameter side first, onto each end of the
5
bushing pin.
Reinstall the shock to your bicycle frame according to the bicycle
6
manufacturer's instructions.
Use a shock pump to pressurize the shock to the desired air pressure. After adding air to the shock, the pressure will need to be equalized
7
between the shock chambers.
Record the air pressure value on the pump, then unthread it from the shock. Slowly but firmly press or sit on the saddle to compress the shock
until there is a hissing sound.
This sound indicates air transfer between chambers. Record the air pressure, then unthread it from the shock. Repeat this process until you
reach the desired amount of sag, then install the valve cap.
N OTIC E
When pressurizing the shock, do not exceed maximum pressure rating.
The pump must be removed from the shock prior to checking sag to avoid damage to the pump.
This concludes the service for the RockShox® Deluxe™ rear shock.
Mounting Hardware Installation 47