SRAM RockShox Deluxe RT3 Service Manual page 32

Use a pick to pierce and remove the internal seal o-ring located in the
9
internal seal gland.
Install a new internal seal o-ring into the seal gland.
Use a pick to remove the inner o-ring, located at the base of the
10
threads in the seal head/air piston.
Install a new inner o-ring into the seal head/air piston.
Use a 1.5 mm hex wrench to push the compression ball out of the
11
backside of the seal head through the bleed port.
Do not replace the compression ball at this time; you will
replace it later.
Do not reuse the compression ball.
Use your fingers to remove the o-ring located inside the shaft
12
eyelet threads.
Install a new o-ring inside the shaft eyelet threads.
1.5 mm
Piston Service 32