SRAM RockShox Deluxe RT3 Service Manual page 28

Use a 2 mm hex wrench to remove the bleed screw, located in the
4
seal head/air piston.
Wrap a rag around the damper body.
5
Use a 17 mm open end wrench to loosen the seal head/air piston
assembly from the damper body. Use your hand to remove the
assembly.
⚠ CAUTI ON - EYE HAZARD
If fluid is foaming from the damper body when the seal head/air piston
is loosened, the IFP seal has failed and the fluid inside the damper
is pressurized. This can cause the seal head/air piston assembly and
damper fluid to forcefully eject from the damper body. Cover the seal
head/air piston assembly with a rag and slowly loosen the assembly to
allow the pressurized fluid to leak out between the damper body and
seal head/air piston assembly.
Fluid will spill from the damper body.
Remove the damper body from the vise and pour the fluid
6
into an oil pan.
2 mm
17 mm
Damper Body Service 28