IDEAL EVO S 50 Installation And Servicing page 99

Adjust the clock rate
• Heating circuit 1 / 2 menu
Adjust the comfort setting
Adjust the curve slope
• Switch the heating regime to permanent comfort
• Domestic hot water menu
Adjust the comfort setting
• Activate the DHW mode
• Configuration menu
Save the sensors
On boiler n°2 or the following boilers: slave
• Configuration menu
Boiler pump supplied by IDEAL
Boiler pump supplied by the customer
(all-or-nothing control)
Start the third heating circuit
Start the fourth heating circuit
Configure the alarm output
Configure the extension modules
• Configure as a slave of the cascade: LPB network menu
Appliance number
27.08.2018
Diagram: VF11
Heating curve slope (720/1020)
Function extension module 1
Function extension module 2
EVO S - Installation and Servicing
Line No.
Clock mode (6640)
Comfort setpoint (710/1010)
Nominal setpoint (1610)
Save sensors (6200)
No adjustments necessary
Relay output QX3 (5892)
Heating circuit 1 (5710)
Heating circuit 2 (5715)
Relay output QX1 (5890)
(6020)
(6021)
Device address (6600)
page 5 / 9
Value
Master
- - -
- - -
- - -
Yes (switches back
to no automatically)
Boiler pump Q1
On
On
Alarm output K10
Heat circuit 1
Heat circuit 2
2 (or following, for
the other slaves)
99 / 136