IDEAL EVO S 50 Installation And Servicing page 27

4.5.1. Installing the propane injector
IMPORTANT:
Nut
IMPORTANT:
27.08.2018
ONLY EVO S 70 and EVO S 95 model boilers.
Change the type of gas by installing an injector at the gas valve inlet.
Close the gas feed valve and switch off the electric power supply.
Disconnect the electric cable and connect on the gas valve.
Undo the two nuts before and after the valve (see figure below) and remove
the valve from the boiler.
Undo the four screws (see below).
Install the injector.
Install the assembly.
Gas valve
Nut
figure 10 - Installing the propane injector
Always replace the washers on the two nuts.
Check the seals.
EVO S - Installation and Servicing
Screw (x4)
Propane injector
ø
S 70: 6,5
ø
S 95: 7,0
27 / 136