Table of Contents
Advertisement
OPERATING INSTRUCTIONS (continued)
System Reset:
This will return the fixture to its factory settings.
1. Plug the fixture in and press the MODE button until "OPTION" is displayed.
2. Press the SET UP button until "SYSRESET" is displayed.
3. Press the UP and DOWN buttons simultaneously to reset or press the MODE button to exit.
Dimmer Curve:
This is used to set the dimming curve used with DMX mode. See page 20 for the different dimming curves.
1. Plug the fixture in and press the MODE button until "DMX MODE ADDR: XXX" is displayed.
2. Press the SET UP button until "DELAY: X" is displayed. "X" represents the displayed dimmer curve (0-4).
• 0 - Standard
• 1 - Stage
• 2 - TV
• 3 - Architectural
• 4 - Theatre
3. Press the UP or DOWN buttons to scroll through and select your desired dimming curve.
DMX State:
This mode can be used as a precaution mode, that in case the DMX signal is lost, the operating mode chosen
in the setup is the running mode the fixture will go into when the DMX signal is lost. You can also set this as
the operating mode you would like the unit to return to when power is applied.
1. Plug the fixture in and press the MODE button until "DMX MODE ADDR: XXX" is displayed.
2. Press the SET UP button until "DMX MODE NO" is displayed. The current DMX state will be displayed.
• "BLACK" (Blackout) - If the DMX signal is lost or interrupted, the unit will automatically go into standby mode.
• "HOLD" (Last State) - If the DMX signal is lost or interrupted, the fixture will stay in the last DMX set up.
• "AUTO" (Auto Run) - If the DMX signal is lost or interrupted, the unit will automatically go into Auto Run
mode.
• "MANUA" (Manual) - if the DMX signal is lost or interrupted, the unit will automatically go into the last color
set up in manual dimmer mode.
3. Press the UP or DOWN buttons to scroll through and select your desired DMX state.
ADJ UC IR & Airstream:
This function is used to activate and deactivate the infrared sensor. When this function is activated the unit can
be controlled using the ADJ UC IR or Airstream IR app. Please see page 19 for remote controls and functions.
1. Plug the fixture in and press the MODE button until "OPTION" is displayed.
2. Press the SET UP button until "IR: XX" is displayed.
3. Press the UP or DOWN buttons to either activate the remote function (On) or deactivate it (Off).
MASTER-SLAVE CONFIGURATION
Master-Slave Configuration:
This function will allows the user to link units together to run in a Master-Slave set-up. In a Master-Slave set
up. one unit will act as the controlling unit and the others will react to the controlling units running mode. Any
unit can act as a Master or as a Slave, however, only one unit can be programmed to act as the "Master."
Master-Slave Connections and Settings:
1. Daisy chain the units via the XLR connectors on the bottom of the unit. Use standard XLR data cables to
link the units together. Remember that the Male XLR connector is the input and the Female XLR connector is
the output. The first unit in the chain (master) will use the female XLR connector only. The last unit in the chain
will use the male XLR connector only.
2. Connect the first "Slave" unit to the "Master."
3. Set the "Master" unit to a desired mode of operation. On the "Slave" unit's press the MODE button until
"SLAVE MODE" is displayed. The "Slave" unit(s) will now follow the "Master".
A.D.J. Supply Europe B.V. – www.americandj.eu – MOD TW100 Instruction Manual Page 18
Advertisement
Table of Contents
