Master-Slave Configuration - ADJ ENCORE FR50Z User Instructions

Encore FR50z

Master-Slave Configuration:

This function will allows you to link units together to run in a Master-Slave set-up. In a Master-Slave
set up one unit will act as the controlling unit and the others will react to the controlling units built-in
programs. Any unit can act as a Master or as a Slave however, only one unit can be programmed to
act as the "Master."
Master-Slave Connections and Settings:
1. Daisy chain your units via the XLR connector on the rear of the unit. Use standard XLR data
cables to link your units together. Remember that the Male XLR connector is the input and the
Female XLR connector is the ouput. The first unit in the chain (master) will use the female XLR
connector only. The last unit in the chain will use the male XLR connector only.
2. Connect the first "Slave" unit to the "Master."
3. Set the "Master" unit to your desired mode of operation. On the "Slave" unit's press the UP or
DOWN buttons until "Function" is displayed, and press ENTER.
4. Press the UP or DOWN buttons until "Disp.Set" is displayed and press ENTER. Press the UP or
DOWN buttons until "Slave" is displayed and press ENTER.
5. The "Slave" unit(s) will now follow the "Master".
6. To exit "Slave" mode, press the MODE button.
7. To fully exit "Slave" mode, you will need to follow steps 3 and 4 and set the display to "ADDR"
and press ENTER.
Encore FR50z
Zoom Adjustment Knob:
Rotate this know counter-clockwise
for a wider beam.
Rotate this knob clockwise for
narrower beam.
ADJ Products, LLC - www.adj.com - Encore FR50z User Manual Page 13
Master-Slave Configuration
Zoom Adjustment Knob