Table of Contents
Advertisement
SNOOT EFFECT
The body of the MOD TW100 can easily be adjusted to create a Snoot Effect to eliminate side glare. Loosen
the bracket knobs and slide the innards up and down using the bracket. Find your optimal setting and tighten
the bracket knobs to lock the body in place.
ADJ UC IR/ AIRSTREAM IR CONTROL
The UC IR infrared remote gives you control of various functions (See below). To control the fixture you must
aim the remote at the front of the fixture and be no more than 30 feet away. To use the ADJ UC IR you must
first activate the fixtures infrared sensor, to activate the sensor please see the instructions on page 18.
The Airstream IR remote transmitter plugs into the headphone jack of your iOS phone or tablet. To control
your IR fixture you must raise the volume to the maximum on your iOS phone or tablet and aim the transmitter
at the fixture sensor and be no more than 15 feet away. After you have purchased the Airstream IR
transmitters, the app is a free download from the app store for your iOS phone or tablet. The app comes with 3
pages of control depending on the fixture you are using. Please see below for IR functions including the
corresponding app page.
Works with App page 1
STAND BY - Pressing this button will blackout the fixture. Press the button again to return to the initial state.
FULL ON - Press this button down to fully light up the unit. Press this button again to return the unit to its last
mode of operation.
FADE/GOBO - Press this button to switch between color change mode, color fade mode, and auto run mode.
"DIMMER +" and "DIMMER -" - Use these buttons to adjust the output intensity.
STROBE - Press this button to activate strobing. Use buttons 1-4 to adjust the strobe speed. "1" being the
slowest, "4" being the fastest. Press this button again to stop strobing.
COLOR - Press this button to activate color mode. Use buttons 1-9 to find your desired color.
Buttons #1-6 = Colors 1-6
Button #7 = Color 20
Button #8 = Color 25
Button #9 = Color 32
1-9 - Use buttons 1-9 to select your desired color when color mode is active or your desired program when
show mode is active. Use buttons 1-4 to select you desired strobe rate when strobing is active.
SOUND ON & OFF - Use the buttons to activate and deactivate sound active mode.
SHOW 0 - Press this button to activate color fade mode. Use buttons 1-8 to select your desired show.
A.D.J. Supply Europe B.V. – www.americandj.eu – MOD TW100 Instruction Manual Page 19
Advertisement
Table of Contents
