Master-Slave Configuration - ADJ VIZI CMY300 User Instructions

Vizi CMY300
With this feature you are able to control the unit with DMX without the need of XLR cables. Your
DMX controller must be connected to a ADJ WiFly TransCeiver or have WiFly wireless DMX remote
to use this function. You are able to communicate up to 2500 feet/760 meters (open line of sight).
1. Follow the instructions on page 30 to activate WiFly and set the Wireless address. The address
must match the address set on the WiFly Transceiver.
2. After you have set the WiFly address, follow the DMX instructions on page 29 to select your
desired DMX Channel mode and set your DMX address.
3. Apply power to the ADJ WiFly Transceiver. The fixture must be set up first before you apply
power to WiFly Transceiver.
Note: If the sync does not work, switch the WiFly power off then on again.
Vizi CMY300
This feature will let you link units to run in a master-slave mode without the use of XLR cables.
1. Follow the instructions on page 30 to activate WiFly and set the Wireless address. The
address must match the address set on the WiFly Transceiver.
2. After you have set the WiFly address, select your master unit and set your desired DMX
channel mode.
3. For the Slave units, set the wireless DMX address to same address as the Master unit.
NOTE: If they do not sync up master-slave, switch the Master fixtures WiFly off then on again.
Vizi CMY300

Master-Slave Configuration:

This function will allows you to link units together to run in a Master-Slave set-up. In a Master-Slave
set up one unit will act as the controlling unit and the others will react to the controlling units built-in
programs. Any unit can act as a Master or as a Slave however, only one unit can be programmed to
act as the "Master."
Master-Slave Connections and Settings:
1. Daisy chain your units via the XLR connector on the rear of the unit. Use standard XLR data
cables to link your units together. Remember that the Male XLR connector is the input and
the Female XLR connector is the ouput. The first unit in the chain (master) will use the female XLR
connector only. The last unit in the chain will use the male XLR connector only.
2. Connect the first "Slave" unit to the "Master."
3. Set the "Master" unit to your desired DMX mode. Connect the "Slave" unit's and they will now
follow the "Master".
ADJ Products, LLC - www.adj.com - Vizi CMY300 User Manual Page 34
WDMX (WiFly) Set Up
Wireless Master-Slave Set Up
Master-Slave Configuration