Focus And Zoom Adjustments; Master-Slave Configuration; Gobo Install - ADJ ENCORE PROFILE 1000 WW User Instructions

FOCUS AND ZOOM ADJUSTMENTS

The knobs located on the right side of unit are used to adjust the focus and the zoom. For a tighter/narrow
beam move the first/front knob to the front of the fixture, and move the second knob to rear. For a wider beam,
move the first/front knob towards the middle of the fixture, and move the second knob towards the middle as
well. Adjust accordingly.

MASTER-SLAVE CONFIGURATION

Master-Slave Configuration:
This function will allows you to link units together to run in a Master-Slave setup. In a Master-Slave set up one
unit will act as the controlling unit and the others will react to the controlling units built-in programs. Any unit
can act as a Master or as a Slave however, only one unit can be programmed to act as the "Master."
Master-Slave Connections and Settings:
1. Daisy chain your units via the XLR connector on the rear of the unit. Use standard XLR data cables to link
your units together. Remember that the Male XLR connector is the input and the Female XLR connector is the
output. The first unit in the chain (master) will use the female XLR connector only. The last unit in the chain will
use the male XLR connector only.
2. Set the "Master" unit to your desired mode of operation.
3. On the "Slave" units press the MODE button until "Slave Mode" is displayed. The unit is now set as the
"Slave" unit. Each slave unit must be set to the same setting.
4. Connect the first "Slave" unit to the "Master", and the "Slave" unit should now start to follow the "Master".

GOBO INSTALL

The Encore Profile 1000 WW comes with 4 replaceable gobos (see below). To install a gobo, unscrew and
remove the phillips screw located at the bottom of the gobo holder. Gently lift part of the gobo holder side up
and carefully slide the gobo into place. Reinstall the phillips and screw and tighten. Slide the gobo holder into
the slot located at the top of the unit in front of the framing lever.
A.D.J. Supply Europe B.V. – www.americandj.eu – Encore Profile 1000 WW Instruction Manual Page 9