Table of Contents
Advertisement
Starship
AUTO MODE/SOUND ACTIVE:
This function will allow the unit to run its auto program. The auto program can be run normally or in a
sound active state with adjustable sound sensitivity.
1 Press the MENU button to enter the main system menu. Press the UP or DOWN buttons so that
"DMX Settings" is highlighted and press ENTER.
2. Press the UP or DOWN buttons so that "No DMX Status" is hightlighted and press ENTER.
Press the UP or DOWN buttons so that "AUTO" is highlighted and press ENTER.
3. Press the MENU button to exit to the main system menu. Press the UP or DOWN buttons so
that "Personality" is highlighted and press ENTER. Highlight "Master" and press ENTER. Select
"ON" and press ENTER. NOTE: Make sure that the "Slave" Mode is "OFF".
4. Press the MENU button to exit to the main system menu. Press the UP or DOWN buttons so that
"AUTO" is highlighted and press ENTER.
5. When entering the the AUTO menu, you have the choice of running the AUTO mode as sound
active and adjusting the sound sensitivity. "000" being the least sound sensitive, and "100" being
the most sound sensitive.
6. Make your desired adjustments and press the MENU button to exit to the main system menu.
Press the MENU button again so that the DMX address is displayed.
Starship
Master-Slave Configuration:
This function will allows you to link units together to run in a Master-Slave mode. In Master-Slave
operation one unit will act as the controlling unit and the others will react to the controlling units
built-in programs. Any unit can act as a Master or as a Slave however, only one unit can be pro-
grammed to act as the "Master."
Master-Slave Connections and Settings:
1. Daisy chain your units via the XLR connector on the rear of the unit. Use standard XLR data
cables to link your units together. Remember that the malle XLR connector is the input and the
female XLR connector is the ouput. The first unit in the chain (master) will use the female XLR
connector only. The last unit in the chain will use the male XLR connector only.
2. Set the "Master" unit to your desired operating mode.
3. Press the MENU button to enter the main system menu. Press the UP or DOWN buttons so that
"Personality" is highlighted and press ENTER.
4. Press the UP or DOWN buttons so that "Master" is highlighted and press ENTER. Highlight
"ON" and press ENTER, then press the MENU button to exit.
5. For the "Slave" unit(s) press the MENU button to enter the main system menu. Press the UP or
DOWN buttons so that "Personality" is highlighted and press ENTER.
6. Press the UP or DOWN buttons so that "Slave" is hightlighted and press ENTER. Highlight
"ON" and press ENTER, then press the MENU button to exit. The "Slave" unit(s) will now follow
the "Master" unit.
ADJ Products, LLC - www.adj.com - Starship User Manual Page 24
Operating Mode - Auto Mode
Master-Slave Configuration
Advertisement
Table of Contents
