Master/Slave Configuration - ADJ 6-PACK SKB CASE User Instructions

Element HexIP Pearl
life expectancy of the battery maybe shortened or the device
in which the battery is used may be damaged by electrolyte
gel leakage. If the batteries cannot maintain a charge for long
periods of time, even when they are charged correctly, this may
indicate it is time to change the battery.
6. Battery Disposal
Please dispose of battery according to local regulations.
ADJ Products, LLC - www.adj.com - Element HexIP Pearl User Manual Page 9
Battery Precautions Element HexIP Pearl
This unit can only be controlled using WiFly. Your DMX controller must
be connected to a ADJ WiFly Transceiver to use this function. You are
able to communicate up to 2500 feet/760 meters (open line of sight).
1. Follow the instructions on page 29 to set the WiFly address and to
activate WiFly. The address must match the address set on the
WiFly WiFly Transceiver.
2. After you have set the WiFly address, follow the DMX instructions
on page 27 to select your desired DMX Channel mode and set
your DMX address.
3. Apply power to the ADJ WiFly Transceiver. The fixture must be set
up first before you apply power to WiFly Transceiver.
4. If everything is set up properly and the fixture is receiving a
Wireless signal, you should now be able to control it with a DMX
controller.
Element HexIP Pearl
Master-Slave Configuration:
This function will allows you to link units together to run in a Master-
Slave setup. In a Master-Slave set up one unit will act as the control-
ling unit and the others will react to the controlling units built-in pro-
grams. Any unit can act as a Master or as a Slave however, only one
unit can be programmed to act as the "Master."
1. Follow the instructions on page 29 to set the WiFly address and to
activate WiFly. The addresses on each fixture must be the same.
2. After you have set the WiFly address, select your "Master" unit
and set your desired operating mode.
3. For the "Slave" unit(s), put the unit in Slave mode. See page 29
SLAVE SETTING to set the unit as a Slave.
4. If everything is set up correctly, the "Slave" units will start follow-
ing the "Master" unit.
ADJ Products, LLC - www.adj.com - Element HexIP Pearl User Manual Page 30
WiFly Set Up
WiFly Master-Slave Set Up