Selecting Sounds On The Pr·300 - Rodgers PR-300 Owner's Manual

*This piston is labeled [MIDI GREAT A] on larger
Rodgers organs.
This will tell the organ to transmit on channel 1
when notes are played on the Great Manual. LTG
MIDI Phase II organs will transmit on MIDI
channel 2.
(3) Play notes on the Great manual of the organ.
The Rodgers organ will send MIDI information to
thePR-300 and an instrument will play.
*If you are not getting any sound, check the
following things:
- Are all cables connected correctly?
- Is the PR-300 turned on?
- Is the [VOLUME] slider of the PR-300 adjusted
correctly?
Selecting Sounds on the PR·300
Obviously, you want to have some control over
which sound is played from the Great manual of the
organ. There are a few different ways to select the
sound which is controlled by the Rodgers organ.
The first way is to use the Sound Function on the
PR-300. The Sound Function assigns a specific
sound to a MIDI channel.
As the Great Manual of the Rodgers organ sends on
MIDI channell, we will use the Sound Function of
the PR-300 to assign a sound to MIDI Channell.
As an example, we will assign "Harpsichord" to
MIDI Channell:
MIDI Channel 1
. .
•
PR-300
(1)
Press [SOUND].
This button is located under the top panel.
Press [BEAT] if .. prompt is not located in the top
left comer of the display.
(2) Rotate the alpha-dial (if necessary) to select
"Part 1".
SOUND
EFFECTS
b•. C' -
t-.t
a
1
~. I
-::I _.
a
Pi.::ino 1
~.p
.::it-·t. : 1
Pi.::ino 1
1-
[1
1-
[1
Each part communicates on its corresponding MIDI
channel. For example, "Part 1" communicates on
21
Press [SEAT] if
.~
prompt isn't in
this location