Punch Wout Using The Button Or Pedal - Rodgers PR-300 Owner's Manual

(3) Jump to the Punch In point by pressing Marker
A.
(4) Press [BWD] a few times to back up a few
measures.
(5) Press
[REe].
«()
Press the Track button for the track you wish to
re-record.
(7) Press [PLAY].
The previously recorded infonnation will play and
the light above the [REC] button will blink red.
You can play along with the previously recorded
information, if you wish, however, nothing you
play at this point will be recorded.
When you reach the Punch In point (Marker A), the
previously recorded information will no longer be
heard and the information you play will be
recorded (you will write over the old information
with the new information you play). The light
above the
[RECl
button will stay red during this
recording process.
When you reach the Punch Out point (Marker B),
the PR-300 will stop recording and normal
playback will begin again (the light above the
[RECl
button will start flashing red again).
(8) Press [STOP] when you are finished recording.
Punch In/Out Using the Button or Pedal
This procedure allows you to select the
Punch
In
and Punch Out points during the
recording process by pressing the [REel
button or a DP-2 Pedal.
If you want to use a DP-2 Pedal to
determine the Punch In and Punch Out
points, you must connect it as described
earlier in this chapter.
• 0
A·MARKER·B
~-
BWD
lID
0 0 0 0 0
TRACK
(
R
lC(i5)(
2
)(
3
)(
4
)
•
PLAY
..
105