Table of Contents
Advertisement
Synchronizing the PR-300 with Other Devices
Sometimes, you may want to transfer music data
from other MIDI devices (such as external
sequencers) over to your PR-300. Synchronizing your
PR-300 with an external sequencer is a good way to
do this. When your PR-300 is synchronized to an
external MIDI device, it will start and stop
automatically and stay in time with the external
device's tempos.
There are two different configurations for
synchronizing your PR-300 with an externa.!
sequencer: one where the entire performance except
Connecting the PR·300 to an External Sequencer
To connect the
PR-300
to an External Sequencer:
(1) Connect a MIDI cable from the external
sequencer's
OUT
jack to the PR-300's IN jack.
(2)
Set the external sequencer so that it transmits
MIDI clock messages to the PR-300.
Setting PR·300 Synchronization
Now, we need to tell the PR-300 to synchronize
itself to the external sequencers
clock
messages:
tempo changes is transferred; one where the entire
performance including tempo changes is transferred.
The configuration used is determined by the status of
the Sync and Tempo Rec modes of the PR-300 (see
chart below).
TEMPO REC Off
TEMPORECOn
SYNC
Record music onto
Record tempo changes
INT
a track
with the alpha-dial
Record music onto a
SYNC
Record music onto
track and record tempo
IN
a track in sync with
changes in sync with
external clock
external clock
(1) Press the [MIDI] button and rotate the alpha-
dial, if necessary, to select the screen shown at
right.
This button is located underneath the top cover.
(2) Use the
[>]
button to move the cursor to the
right and rotate the alpha-dial to select "Sync:
IN" •
This tells the PR-300 to listen to the incoming
MIDI clock messages.
(3) Press [ENTER].
The
Play
Screen will return.
t'1IDI
IP-S':wlch
t'1ICH
S'=,nch
:Int.
110
Hide quick links:
Advertisement
Table of Contents
