Copying A Song On The Disk - Rodgers PR-300 Owner's Manual

(5) Press [ENTER] once you've finished naming the
song.
The PR-300 will ask if you're sure you want to save
the song.
(6) Press [ENTER] to save the song. Press [STOP]
to cancel.
The PR-300 will say "Please Wait" for a few
seconds, after which time the Play Screen will
return.
Copying a Song on the Disk
Use this procedure to copy a song to a different
disk (or to another song numl:>er on the same disk).
To copy a song:
(1) Insert the disk you want to copy from into the
PR-300's disk drive.
(2) Hold [SHIFT] and press [DISK].
3:
O'-~t-'Son':;I
Sal.}e S'-~to'e?
MIDI
The screen at right should be seen in the display. If
it doesn't, rotate the alpha-dial until it appears.
(3) Press [ENTER].
If you have not saved a new song or saved changes
to an existing song, the PR-300 will ask, "Data will
be erased. Ok?", (asking if you want to save the
song you were working on). If you press
[ENTER], all work done since the last Save will be
lost. If you don't want to lose this work, press
[STOP], save the song and start this procedure
again.
(4) Select the song you want to copy by rotating the
alpha-dial, then press [ENTER].
This is called the "Source Song", or the song you
are copying from.
(5) Select the number of the song you want to copy
the Source Song to by rotating the alpha-dial.
TRANSPOSE
tJ:jjjjj!!;j!!jjjjjl
~elect
Sorc.Song
IIr 1: t' 1 ' : :1 Song
This is called the "Destination Song", or the song
you are copying to. If you select the number of an
existing song, you will write over that song with
the song you are copying.
· -l--·L
':11::' J::=i_- J...
[ '1.
0
-t
·--t
o
.....
. 1:::' : ::.
0'.
':11_, !
='
123