Using The Repeat Play Function - Rodgers PR-300 Owner's Manual

Listening to a Song on Disk, cont.
Using the Repeat Play Function
With the Repeat Play function, you can set Markers at
the beginning and end of a particular section of music
and instruct the PR-300 to repeat that section over and
over again.
The PR-300 Markers set the boundaries for the Repeat Play
function. The two marker buttons (labeled "MARKER A" and
"MARKER B") are located on the left side of the unit near the
power switch. Marker A is used to set the beginning boundary
of the repeated section; Marker B is used to set the ending
boundary,
SONG
lCP2l
I
1 4.····4IirJ=12[1
In this example, we'll use the demo song we've
used before, "Mozart K-336". Select this song (if
it's not already selected) by pressing the [SONG]
button and rotating the alpha-dial.
BWD FWD
ilia 1m
(1) Use the [FWD] and [BWD] keys to go to
measure 15.
T
Select measure 15 in the display
(2) Press [MARKER A] so that its light comes on.
This sets the beginning boundary of the repeated
section at the start of measure 15.
(3) Use the [FWD] and [BWD] keys to go to
measure 19.
• 0
A-MARKER-B
Press [MARKER A] to set
beginning of repeated section
at the start of measure 15.
I:::'u
t'1- ..... - -t
l.·' ..,...,..-
,_I
u
I_I..:..
-::I
t· _.
p" - •..:••..:"::'
19 4.···"4IirJ = 12[1
,
T
(4) Press [MARKER B) so that its light comes on.
Select measure 19 in the display
This sets the ending boundary of the repeated
section at the start of measure 19.
16
•
•
A·MARKER·B
Press [MARKER B) to set end
of repeated section at the start
of measure 19.