Replacing Of Throttle Lever - Taski swingo 855B Power Technical Manual

GTS

5.1.1.3 Replacing of throttle lever

Remove
•
•
•
•
•
•
•
Remarks
The lever parts can be replaced as single pieces according to e-
spares.
Picture 4: Throttle levers position
Pay attention that the solenoid is placed on the left side (hall sensor
side).
Make sure that the rubber covers are placed in the slots.
Mount
•
Ensure that the lever toothed wheels are positioned in the centre of
the possible movement.
•
•
Make sure that the mechanic hall sensor compl. is placed correctly
on the pins of the support before tightening the screw.
•
•
15. March 2010
Copyright © 2010, Diversey Inc.
Remove microswitch according to chapter REPLACING OF
MICROSWITCH.
Unscrew the four screws of the of switch holder bracket.
Remove switch holder bracket.
Unscrew mechanic hall sensor compl. fixation.
Remove mechanic hall sensor compl.
Put the locking lever to the left.
Remove both throttle levers.
Assemble both throttle levers.
Mount switch holder bracket.
Build in mechanic hall sensor compl.
Place and tighten screw of mechanic hall sensor compl.
Complete assembling according to the chapter REPLACING OF
MICROSWITCH.
Edition: V1.00/2010
Technical Manual
5-5