Log-Out Tag-Out Procedures - EFD Ultra 325TT User Manual

®
A NORDSON COMPANY
WARNING!
on this machine that should be avoided. Failure to do so while the machine is
operating may cause serious injury.
Potential Pinch Hazard
i. LOCK-OUT TAG-OUT PROCEDURE
1. Announce lockout to other personnel.
2. Verify that all dispensing motion has stopped.
3. Turn power OFF at main power circuit breaker at the back of the Ultra TT
4. Disconnect the power cord from the electrical source. Place the power cord in a
location where it can be seen at all time during the maintenance or service.
5. Place a warning tag on the Main Power Inlet.
6. Turn the shut-off valve for the pneumatic circuit to the OFF position
7. Lockout power in OFF position.
8. Put key (if any) in pocket.
9. Clear machine of all personnel.
10. Test lockout by hitting RUN button.
There are several pinch points (indicated with yellow hazard stickers)
Ultra TT User's Guide
Version 1.2
7