Inserting A Do Program Instruction - EFD Ultra 325TT User Manual

®
A NORDSON COMPANY
2. To apply Step and Repeat to the entire program, select On.
3. Enter the number of rows and columns corresponding to the
parts on the fixture. Select either traversing via row or column.
Check the Serpentine box if desired.
Corresponding to the above 4-dots example, we have taken 4
dots and program origin and stepped and repeated them in a 2X2
matrix. For a Y serpentine, you would select step and repeat on
rows = 2, columns = 2, Traverse = Column, Serpentine =
symbol.
4. Tap the Origin "Go To" button to check that the needle tip lines up with the origin of the
program.
5.7

INSERTING A DO PROGRAM INSTRUCTION

For some applications, it may be necessary to insert a program into another. An example: if there
already exists a program to dispense solder paste pattern for 1.25mm BGA, this program could be
inserted at specific point on a new program being created for a circuit board. It is important to
note that the dot and line parameters of the original program become null and void. The Operator
must set new parameters in the higher level/current program.
5. Tap the Row End "Edit" button and jog tip to the origin point of
the first row's end position. Tap "Teach" before tapping "OK" to
return to the previous screen.
6. Repeat (5) for the Column End.
1. From the main Program screen, tap "Insert" to open the Select
Instruction screen.
Ultra TT User's Guide
pi
Version 1.2
45