Setup; Setup Procedures - EFD 2000XL Operating Manual

Setup

Power switch should be off.
Mounting
Included is a universal mounting bracket. Mounting
hardware is installed into the four 10-32 mounting
holes on the sides of the cabinet. The bracket can be
mounted either over or under the cabinet and will
allow the dispenser to pivot up or down 30° from a
horizontal position. The bracket may be permanently
mounted, or attach the rubber feet included and use
the bracket as a bench-top tilt stand. Four rubber feet
on the console are provided if the bracket is not used.
Input power
Check the input power cord receptacle. To change
voltage, remove the voltage selector from the car-
tridge, rotate it and position the correct voltage to
show through the cartridge window. Replace the
cartridge into the power cord receptacle and insure
that both sides snap securely into position.
Install the power cord.
Initiate connection
The 2000XL is normally operated using the foot pedal
supplied. Plug the foot pedal into the connector
located on the rear panel. An alternate method is to
apply a 5 to 24 VDC pulse to terminals 1 and 2.
Air input connection
A 6 ft. air input hose kit is supplied. Connect the input
hose to filtered, dry plant air. For models 2000XL and
2000XL-CA, set plant air supply within 80 to 100 psi
(5.5 to 6.9 bar). For model 2000XL-PR5, input air
should be set within 10 to 50 psi (0.7 to 3.4 bar).
Attach the air input hose coupling to the dispenser.
Pull back metal ring to attach to dispenser.
Spare fuse
2 2
0
0
0
1
Voltage value
Cartridge window
Note: Check voltage indicated
Fuse T 125mA 250V
100/120/220VAC
50/60Hz 10/9VA Air
Output
+
1. Initiate 5. Contact Closure
5-24 VDC
-
2. Initiate 6. Chassis Ground
7. Contact Closure
+
3. Output 5-24 VDC 8. Not Used
-
4. Output 250mA 9. Not Used
Note: If filtered, dry air is not available, order an
EFD five-micron filter regulator #2000F755.
(2000XL-CA units are supplied with a five-micron
coalescing filter regulator.)
Exhaust
Foot
Pedal
Air
Input