EFD Ultra 325TT User Manual page 60

®
A NORDSON COMPANY
B. Lubrication of Cable
i. Use a lint-free cloth to wipe down cables and pulleys.
ii. Move the axis to home position i.e. X-axis to left most position and Y-axis to the rear
of the machine.
iii. Apply a light coat of grease (Molygraph #40-0037) to cables and pulleys.
iv. Move the axes to maximum travel limit i.e. X-axis to rightmost position and Y-axis to
front of the machine.
v. Repeat Step (iii).
vi. Move each axis back and forth for the entire length of the rail four (4) times.
vii. Wipe away any excess grease.
C. Tensioning of Cable
i. After lubricating the cables, it is a good idea to re-tension the cables.
ii. Locate the tension block.
iii. Loosen the two screws to the tension block.
iv. Move the axis back and forth for two (2) complete cycles.
v. Move the carriage back to approximately the center of the axes.
vi. Tighten the tension block, with the carriage at mid-travel.
vii. Replace covers.
Ultra TT User's Guide
Version 1.2
60