Teaching A Dot - EFD Ultra 325TT User Manual

®
A NORDSON COMPANY
5.3

TEACHING A DOT

Next, we will program four dots and set the desired dot parameters
(Figure A on the template).
1. In the Program menu, tap "Insert" to start inserting program
instructions. This will open the Select Instruction window.
4. If the toggle bracket is selected in the Setup window, the toggle
box will be visible to the Operator to select. Check the "Use
Toggle" box if the dispense is to use the toggle valve/syringe-
barrel. Teach the dispense location (Refer to 3 above) using the
toggle valve or syringe-barrel.
Note that when the program is running, the toggle will actuate i.e. move down, before it begins
to move to the taught dispensed location.
7. Jog to the next dot location. Select a dot type, if different from
the earlier selection. There can be up to ten unique dot types per
program.
8. Tap "Done" once all four Dot instructions have been taught. This
will take you back to the main Program window.
2. In the Select Instruction menu, select Dot and tap "OK".
3. You are now required to teach the first dot position. Tap "Jog" to
open the Jog window. Position the dispense tip to the first point
and tap "OK".
Select a number for Dot Type.
Tap "Edit" to open the Dot
Parameter window.
5. Enter the desired value for each Dot Parameter field. Refer to
Appendix D for a detailed description of the different parameters
that make up a Dot Type. When done, tap "OK".
6. Tap "Teach Dot" to insert instruction. Each time "Teach Dot"
button is pressed the line number will increment (circled in the left
graphics). It allows the user to (1) verify that the Teach was taken
and (2) confirm which instruction is being inserted / edited.
Ultra TT User's Guide
Version 1.2
38