Jogging Your Machine - EFD Ultra 325TT User Manual

®
A NORDSON COMPANY
The factory set defaults will appear. To change the settings, tap the
field you want to change and enter the new value. Tap the "OK"
button to save your new settings. To change the machine's jog
preference, tap the "Send" button. This will cause the front panel jog
to mimic the preference stored in the PDA. To change the jog
preference back to factory defaults, tap the Reset button.
You have several ways to move the dispense tip, i.e. typing in the XYZ coordinates, using the blue
field and compass rose or using the hard buttons on the Palm' handheld.
A.1 USING THE BLUE FIELD AND COMPASS ROSE
The blue field in the Jog window represents the work envelope. By tapping in the blue field, you
can produce gross XY movements at the zero or safe Z-height. The location can then be further
refined using the compass rose.
Holding or tapping a select arrow on the compass rose will move the dispense tip in that direction.
Select between the two modes (XY or Z) by checking the appropriate box. The XY mode allows
you to jog 8 directions, XY and 45° diagonals, while the Z mode allows for the Z-axis movement.
Check box for the appropriate mode
APPENDIX A

Jogging your Machine

The machine is shipped with factory defaults that allow the machine
to be jogged at easily controllable speeds. You can change the
speeds by amending the values in the Preference setting within the
PDA. Note that the jog settings will remain with that PDA even when
connected to various machines. You can also choose to send the
customized preferences to the machine.
To customize the jog preference, tap the
upper left hand corner of the blue menu
bar and select "Options" "Preferences".
Two modes of jogging (XY or Z).
✔ XY
Z
Ultra TT User's Guide
✔
XY Z
Slow or turbo
speed settings.
black= slow
white= turbo
Version 1.2
66