Pda - EFD Ultra 325TT User Manual

®
A NORDSON COMPANY
3

PDA

Before you can start programming, you must first install the EFD Ultra TT PDA software Version 1.2
to your PDA.
Download the Software Installation CD that was included with the PDA to the PC. Once that is
done download the EFD PDA software to the PC. Copy the EFD PDA software to the palmOne
Quick Install and then HotSync to install the EFD PDA software to the palm.
CAUTION: Changes in this area should be performed under strict supervision or by your EFD Ultra
TT representative. Failure to do so may cause programs not to operate or run properly.
Next, plug the pre-configured Socket Adapter that came with your machine to the rear of the
RS232 COM port of the Ultra TT System. Power up the Ultra TT and verify that the Socket adapter
is blinking.
Then, turn the system on by pressing the green power button on the front panel. In the Main Menu,
select Tools > Bluetooth > Discover. Wait about 15 seconds to list any wireless devices in range.
Highlight the EFDSNxxxxx (the"xxxxx" is the 5-digit serial number of the Ultra TT unit) entry in the
list, then tap "Connect".
Enter 1234 as the passkey for the Socket Adapter. Verify that the "Add to trusted devices list"
option is NOT selected, then tap "OK". Your PDA is now paired with the Ultra TT unit.
6
The minimum Palm OS version is 4.0. The following Palm handhelds have been tested and are known to work with the EFD
Ultra TT software and hardware:
With the Teach Pendant Cable (700818): Zire
be used but only with Firmware version 1.1 and above. Sony Clié
machine to be switched (See your EFD Ultra TT Representative for further instructions).
With Bluetooth: Zire 72, Tungsten T, T3, T5 and E2.
Currently, only selected PDA handhelds
EFD Ultra TT programming software. However, it is intended that
the software will be available for other makes of PDA's. Please
check with your Ultra TT salesperson for more information.
Please refer to the Ultra TT User CD for detailed installation
instructions.
The Ultra TT software is divided into three specific sections.
Setup: Setup basic system parameters such as valve selection,
system-park, purge cycle and initial offsets.
Programming: Teach origins, specific points and dispensing
parameters.
Tools: For troubleshooting and advanced software upgrades.
™ 71, Tungsten ™ C, m515, m505 and the m500. The Tungsten T, T2 and T3 can
® PEG-TJ37 may also be used but requires baud rate on
Ultra TT User's Guide
Version 1.2
6 can be used with the
26