Programming; Creating A New Program - EFD Ultra 325TT User Manual

®
A NORDSON COMPANY
5.

PROGRAMMING

5.1

CREATING A NEW PROGRAM

Before you start this exercise, print out the form called "Teaching Template" in Appendix B of this
guide.
6. Tap "Jog" to open the Jog window. Use the compass rose to
move the dispense tip to the position marked "Origin" on the
template.
Refer to Appendix A for detailed jogging instructions.
7. Tap "OK". Tap "Teach" and then "OK". This will open the program
edit window.
7 EFD can supply two tooling plates: 300 X 300mm (P/N 7007-300) or 500 X 500mm (P/N 7007-500). Alternative, user
can design their own (reference System Drawings on Operation CD).
1. Install the tooling plate
printed template on it with cellophane tape.
2. Tap "Program" in the Main screen. This will take you to the
program edit window.
3. From the Program drop-down menu, select New. This will open
a dialog box to name your new program.
4. Type in new program name. Note that program names are case-
sensitive. If an attempt is made to create a new program with
the same name as the program currently opened, an error
message will be displayed.
Ultra TT User's Guide
7 on the Y-carriage and attach the
5. Tap "OK". This will open the Teach
Program Origin window. The
program origin is the point in the
program from which all other
movements relate to, or the (0,0)
coordinate of the program.
Refer to Appendix C for a detailed
explanation of Program Origin.
Version 1.2
36