BMW C evolution Rider's Manual page 73

Fault current test negative
Check the maximum permiss-
ible steady charging current for
the wall socket.
Plug charging cable 2 into the
charging socket 1 on the E-
Scooter. Line up the charging
cable plug and push it in until
the lock 3 engages.
Pay attention to the indicators
on the charging cable.
The standard charging cable
automatically runs all the test
steps required. The test was
successful and charging will
begin if the LED 2 lights up
green. If the LED 4 lights up
red, the test was failed and
the charging procedure can-
not start. The following test
steps are run:
Testing for the presence of a
protective earth
Testing the requirements for
correct charging
The status displays and fault
messages are listed in the
"Technical Data" section.
The symbol 1 for the active
charging procedure and the
remaining charging time 2 are
displayed.
6
71
z