BMW C evolution Rider's Manual page 72

The charging procedure is
6
not started until the operating
readiness is switched off. The
70
charging procedure will be in-
terrupted if operating readiness
is switched back on during the
charging procedure.
Open the flap on the left.
z
Remove the charging socket
cap 1.
Plug in the standard charging
cable from the domestic socket
or the Mode3 charging cable
from the charging station. Fol-
low the instructions on the
charging station if you are char-
ging at a charging station.
The standard charging cable
automatically runs all the test
steps required. The test was
successful if LED 1 lights up
green. If the LED 3 lights up
red, the test was failed and
the charging procedure can-
not start or the charging cable
must not be connected to the
vehicle. The following test
steps are run:
Testing the wall socket for in-
correct wiring
Testing for the presence of a
protective earth
Testing the requirements for
correct charging
The status displays and fault
messages are listed in the
"Technical Data" section. Any
fault messages displayed can
be reset as follows:
Disconnect the standard char-
ging cable from the voltage
supply by unplugging the plug
from the wall socket.
Plug the plug back in after 3
seconds.
Critical faults which indicate
damage to the standard char-
ging cable are not reset. These
faults include:
Relay welded up (equipment
permanently damaged)
Faulty temperature sensor