BMW C evolution Rider's Manual page 70

charging station if you are char-
6
ging at a charging station.
The standard charging cable
68
automatically runs all the test
steps required. The test was
successful if LED 1 lights up
green. If the LED 3 lights up
red, the test was failed and
the charging procedure cannot
start and the charging cable
must not be connected to
the vehicle. The following test
steps are run:
Testing the wall socket for in-
correct wiring
z
Testing for the presence of a
protective earth
Testing the requirements for
correct charging
The status displays and fault
messages are listed in the
"Technical Data" section. Any
fault messages displayed can
be reset as follows:
Disconnect the standard char-
ging cable from the voltage
supply by unplugging the plug
from the wall socket.
Plug the plug back in after 3
seconds.
Critical faults which indicate
damage to the standard char-
ging cable are not reset. These
faults include:
Relay welded up (equipment
permanently damaged)
Faulty temperature sensor
Fault current test negative
Check the maximum permiss-
ible steady charging current for
the wall socket.
Plug charging cable 2 into the
charging socket 1 on the E-
Scooter. Line up the charging
cable plug and push it in until
the lock 3 engages.