BMW C evolution Rider's Manual page 71

Pay attention to the indicators
on the charging cable.
The standard charging cable
automatically runs all the test
steps required. The test was
successful and charging will
begin if the LED 2 lights up
green. If the LED 4 lights up
red, the test was failed and
the charging procedure can-
not start. The following test
steps are run:
Testing for the presence of a
protective earth
Testing the requirements for
correct charging
The status displays and fault
messages are listed in the
"Technical Data" section.
The symbol 1 for the active
charging procedure and the
remaining charging time 2 are
displayed.
The bar display 1 for the state
of charge appears. The state
of charge is also indicated as a
numerical percentage value 2.
After a certain time the TFT
display is automatically switched
to Stand-by-Modus (power eco-
nomy mode).
INFO
Press the or
button briefly to display the
current state of charge again.
Starting the charging
procedure
Switch off operational readi-
ness ( 41).
6
69
z
TRIP