BMW C evolution Rider's Manual page 68

will be indicated by the
6
corresponding charge current
display 1 flashing twice.
66
The Silent Charge mode is
used for charging at a charge
current of 6 A. This minimises
the noise emissions during the
charging procedure by redu-
cing the fan speed.
z
Plug charging cable 2 into the
charging socket 1 on the E-
Scooter. Line up the charging
cable plug and push it in until
the lock 3 engages.
A normal padlock 2 can be
locked in the hole provided to
secure the charging cable 1
against tampering.
Pay attention to the indicators
on the charging cable.
The standard charging cable
automatically runs all the test
steps required. The test was
successful and charging will
begin if symbol 4 lights up
green. If the symbol 4 lights
up red, the test was failed and
the charging procedure cannot
start. The following test steps
are run:
Testing for the presence of a
protective earth
Testing the requirements for
correct charging
The status displays and fault
messages are listed in the
"Technical Data" section.