Protective Wax Coating; Lay Up The E-Scooter; Restore The E-Scooter To Use - BMW C evolution Rider's Manual

BMW Motorrad recommends us-
11
ing BMW tar remover for remov-
ing specks of tar. Remember to
122
wax the parts treated in this way.

Protective wax coating

BMW Motorrad recommends
applying only BMW car wax or
products containing carnauba
z
wax or synthetic wax.
It is time to rewax the paint-
work when water "puddles" on
the surface, instead of forming
beads.

Lay up the E-Scooter

NOTICE
Do not leave the vehicle out of
use for a lengthy period with the
high-voltage battery unit in a low
state of charge. Before leav-
ing the vehicle out of use for a
lengthy period, check the charge
status indicator and make sure
that the high-voltage battery unit
is fully charged.
NOTICE
Check the state of charge at reg-
ular intervals. Otherwise, excess-
ive discharge can damage the
high-voltage battery unit.
NOTICE
Do not leave the vehicle parked
up for more than 14 days if
the electrical range is less
than 10 km. Leave the vehicle
practically fully charged if it is
to be parked up for up to three
months.
Clean the E-Scooter.
Starting the charging proced-
ure ( 64).
Starting the charging proced-
ure ( 69).
Removing 12 V battery
( 109).
Spray the brake-lever, centre-
stand and side-stand pivot
mounts with a suitable lubric-
ant.
Coat bright metal and chrome-
plated parts with an acid-free
grease (e.g. Vaseline).
Stand the E-Scooter in a dry
room in such a way that there
is no load on either wheel.
Restore the E-Scooter
to use
Remove the protective wax
coating.
Clean the E-Scooter.
Installing 12 V battery (
Comply with checklist (
110).
79).