BMW C evolution Rider's Manual page 111

Switch on operational readi-
ness ( 40).
Note the multifunction display:
If you switch on operational
readiness and the multifunc-
tion display fails to light up,
the battery is completely flat.
The 12 V battery will have to
be disconnected from the on-
board circuits and charged with
the battery charger connected
directly to the battery terminals.
If the multifunction display
switches on, the 12 V battery
is not completely flat. The
12 V battery can remain con-
nected to the on-board circuits
and can be recharged via the
12 V power socket.
Switch off operational readi-
ness ( 41).
Removing the side trim panel
( 106).
Charge the 12 V battery using
a suitable charger. In this pro-
cess, comply with the operat-
ing instructions of the charger.
NOTICE
The 12 V battery has to be re-
charged at regular intervals in
the course of a lengthy period of
disuse. See the instructions for
caring for your 12 V battery. Al-
ways fully recharge the 12 V bat-
tery before restoring it to use.
Installing side panel (
Replacing 12 V battery
with alarm system (DWA)
If applicable, switch off the anti-
theft alarm.
Switch off operational readi-
ness.
Removing the side trim panel
( 106).
Disconnect plug 1 for the right-
hand turn indicator.
107).
ATTENTION
Battery not disconnected in
OE
accordance with correct pro-
cedure
Risk of short-circuit
Always proceed in compliance
with the specified disconnec-
tion sequence.
Remove screw 2 and detach
battery earth lead.
Remove screw 3 and detach
positive battery cable.
9
109
z