Fuji Xerox DocuCentre SC2022 User Manual page 382

Unable to print.
The following list describes the possible solutions when you are unable to print.
Problem
Data remains in the
printer icon.
Large amounts of
garbled characters
(symbols) are printed.
Data has been sent to
the machine.
Print Output Problems
The following list describes the possible solutions to the problems with the print output.
382
User Guide
Possible Cause
The machine is turned off.
The Ethernet cable on the
computer is disconnected.
The computer is not connected to
the wireless network.
The cable of the machine is
disconnected or the machine is
not connected to the wireless
network.
An error has occurred on the
machine.
There is a problem in the network
connecting the computer and
machine.
The protocol to use is not
enabled.
The machine is connected to
multiple computers.
A print driver of other
manufacturer's model is used.
Paper is not loaded.
The specified size paper is not
loaded.
An error has occurred on the
machine.
Job execution has been paused.
Action
Turn on the machine.
Refer
• For details, see "Turning On/Off the Machine (P.23)."
Connect the Ethernet cable to the computer.
Connect the computer to the wireless network.
Connect the cable to the machine. When connecting to a
wireless network, make sure that the Ethernet cable is
disconnected from the machine and the optional Wireless LAN
Kit is installed, and then connect the machine to the wireless
network.
Refer
• For details about connecting the Ethernet cable or
USB cable, see "Connecting to a Wired (Ethernet)
Network (P.25)" or "Connecting to a Computer With
USB (P.26)."
• For details about connecting to a wireless network,
see "Connecting to a Wireless Network (P.26)."
Check the error information, and take the required action.
Contact your network administrator.
Enable the protocol to use.
Refer
• For details, see "[Protocol] (P.247)."
Wait for a while and try printing again.
Use the proper print driver. Make sure that the print driver for
the machine is specified on the [Preferences] tab on the
properties screen of the print driver.
Load paper.
Load the specified size paper.
Refer
• For details, see "Loading Print Media (P.67)."
Check the error information, and take the required action.
On the screen, specify whether to cancel the job.