Scanning Problems - Fuji Xerox DocuCentre SC2022 User Manual

Problem
The machine receives faxes but does not
print them out.

13.2.7 Scanning Problems

This section describes how to solve the problems with the scan function.
The following list describes the possible solutions when you are unable to scan.
Problem
The scanner does not work.
The machine scans very slowly.
Document misfeeds or multiple feeds
occur in the Duplex Automatic
Document Feeder (DADF).
Action
Check the toner level.
Make sure that the paper is loaded in the paper tray.
Make sure that [Forward Settings] is set to [Off].
Make sure that [Junk Fax Filter] is set to [Off].
Make sure that [Secure Fax Receive] is set to [Off].
Perform [Initialize NVM] > [Fax Settings].
Action
Make sure that the document to scan is properly loaded as follows.
Document glass: Facing down
Duplex Automatic Document Feeder (DADF): Facing up
There may not be enough memory to store the document to scan. Check that the
preview feature operates properly. Or lower the scan resolution rate.
Make sure that the USB or Ethernet cable is properly connected to the machine.
Check if there are any problems with the USB or Ethernet cable. If any, replace the
cable.
Make sure that the scanner is properly configured. On the software you are using,
check that the scanned data is sent to the correct port.
Photographic images are scanned more slowly than text when you use the Scan to
Email or Scan To Network feature.
Communication speed becomes slow in scan mode because of the large amount
of memory required to analyze and reproduce the scanned image.
Scanning images at a high resolution takes more time than scanning at a low
resolution.
Make sure that the feed rollers of the Duplex Automatic Document Feeder (DADF)
are properly attached.
Make sure that the paper type of the document meets the specifications for the
machine.
Make sure that the document is loaded properly in the Duplex Automatic
Document Feeder (DADF).
Make sure that the document guides are aligned properly.
Check if the number of documents does not exceed the capacity of the Duplex
Automatic Document Feeder (DADF).
Check that the document is curled.
Flex and fan the document well, and then load it in the Duplex Automatic
Document Feeder (DADF).
385
13 Troubleshooting