Mountain Models HiperBipe Instruction Manual page 42

15. Install the motor as shown below, with the
3
included 4-40 x " bolts.
8
16. Install a DuBro EZ Servo Connector onto one end
of the long servo arm of your servo.
17. With your servos centered (power up your radio
to double check), install the servo arms, as shown
below.
20. Slide the pushrod wires into the pushrod tubes, from the back and press the
"L" bend into the control horns on the elevator and rudder. Make sure the
pushrod wires go through the Servo connectors on the servos, as well.
21. Secure the pushrod wires to the control horns with the included DuBro Micro
EZ Links (small white plastic parts).
22. Tighten the screws of the DuBro EZ Servo connectors onto the music wire
and trim the wires about
1
" in front of the servo connectors.
2
18. Install your servos in the fuselage, as
shown below, using the screws included with
your servos.
19. Place an L-Bend at the end of the 2 pieces
of 0.032" wire.
42