Mountain Models HiperBipe Instruction Manual page 39

7. Press the main landing gear wire into the
landing gear mount in the fuselage. Press the
landing gear retainer into the slot to retain the
main landing gear wire. We do not glue the
landing gear wire or the retainer in place, so it can
be removed, if need be later on.
1
Wire pressed into "
32
hole and wrapped with
Spider Wire.
1
8. Drill a " hole through the basswood skid
32
where the tail gear wire should go through. The
angled section of the tail gear wire that leads to
the wheel sits at the back end of the basswood
skid.
9. Press the tail gear into the hole and wrap the
tail gear wire to the basswood skid with the
Spider Wire included in the parts bag. Glue the
wire with Thin CA.
39